I applied through a staffing agency. The process took 1 day. I interviewed at Arm (Bengaluru) in Feb 2015
Interview
There are 3 rounds:
1. Written Test
2. Technical Interview
3. HR Interview
I just attended the written test. It was of 1.5 hours. 30 minutes for 30 aptitude questions and another 1 hour for 40 technical questions (separate paper for Computer Science and Electronics graduates). The main issue was time management. Aptitude questions were average in difficulty, hard to solve all in 30 minutes. Technical questions for Computer Science were from Microprocessor, Computer Architecture, Operating System, C and C++. There were many questions that ask to find out output of a code snippet.
Interview questions [1]
Question 1
Technical questions for Computer Science were from Microprocessor, Computer Architecture, Operating System, C and C++
I applied through an employee referral. I interviewed at Arm (San Diego, CA) in Apr 2026
Interview
1st was a hirevue interview - basic behavioral questions
2nd round was a panel interview - discussion on your resume and technical questions related to power and designing low power circuits
Interview questions [1]
Question 1
Given two processors, how would you determine which is better in terms of power (think about frequency, VDD, temperature etc)
Given a boolean logic, how would you reduce power in this
CV and then virtual interview then final interview through online call. It was basic interview about CV and some technical questions. It was not too difficult and intimidating. Technical interview depends on the role you apply for.
Interview questions [1]
Question 1
What was a difficult problem you encountered during your studies and how did you overcome it.
Interview was done online remotely with a manager and a graduate employee. General questions about previous experience and CB. Then followed by a live code session in Arm assembly with various technical questions.
